How to Reprogram a 1992 Chevy Remote

104 12
    • 1). Locate the data port under the driver's side dashboard in your Chevy and use the jumper wires to connect the number four and number eight terminals in the data port. These terminals are fourth and eighth from the left side on the top of the port.

    • 2). Wait for the locks to cycle automatically, then press and hold your remote's lock and unlock buttons.

    • 3). Hold the buttons for about 15 seconds, until the locks click again, then repeat this step with any additional remotes.

    • 4). Remove the jumper wires from the data port to end the programming procedure.

Source......

Leave A Reply

Your email address will not be published.